Categories
-
- Destocking
- KITS / PACKS
- CARDS / SYSTEMS
- POWER SUPPLIES / PROTECTIONS
- SCREENS / LED / VENTILATIONS
- STORAGE / AUDIO / PHOTO
- PERIPHERALS / NETWORKS
- ROBOTS / PROTOTYPING
- COMPONENTS / TOOLS
- BOOKSHOP / GOODIES
- Raspberry Pi & Micro:bit
- Odroid & Co
- Accessories
- Leisure
- Gift ideas
- French Days
- PM-ROBOTIX
- Raspberry Pi
- Micro:bit
- ARDUINO II
- Other Brands
- Universe
- Gift Cards
- Gift Card Module do not delete
- Gift Card Module do not delete
- Catégories liens 2025
- Probance
- HOME
- New products
- Clearance sale
-
Raspberry Pi
Raspberry Pi
-
Arduino
Arduino
-
Micro:bit
Micro:bit
-
Other brands
Other brands
-
Universe
https://www.kubii.com/fr/512-univers
Universe
- Gift cards
5x5 RGB Breakout Matrix
This super cute 5x5 RGB LED matrix board is a great way to visualize sensor data or for simple animations or notifications, and is compatible with Raspberry Pi and Arduino.
These small arrays are great for viewing data from other boards in a Breakout Garden HAT, such as the environmental data graph from the BMP280 or BME680 boards. Or why not use two sets as headlights or brake lights for your Pi equipped vehicle?
Like our other boards, this one appears directly on the pins of your Pi once soldered. We have included a trace that can be cut to change the I2C address from 0x74 to 0x77, if you want to use two dies at once!
- 5x5 (25 total) RGB LED
- Uses IS31FL3731 driver chip
- Active area 15x15 mm
- No 3.5 mm LED
- I2C interface (address 0x74 / 0x77 (cut-off trace))
- 3.3 V or 5 V compatible
- Reverse polarity protection
- Compatible with all models of Raspberry Pi and Arduino
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent
Questions (0)
No customer questions for the moment.
This super cute 5x5 RGB LED matrix board is a great way to visualize sensor data or for simple animations or notifications, and is compatible with Raspberry Pi and Arduino.
These small arrays are great for viewing data from other boards in a Breakout Garden HAT, such as the environmental data graph from the BMP280 or BME680 boards. Or why not use two sets as headlights or brake lights for your Pi equipped vehicle?
Like our other boards, this one appears directly on the pins of your Pi once soldered. We have included a trace that can be cut to change the I2C address from 0x74 to 0x77, if you want to use two dies at once!
Français
Español
Italiano
Deutsch
Portugais